Contact Us
For further technical information, material safety data sheet (MSDS), or testing services to determine product suitability, correct dosage/application rates and construction methods, please contact your nearest distributor.
For further technical information, material safety data sheet (MSDS), or testing services to determine product suitability, correct dosage/application rates and construction methods, please contact your nearest distributor.
Ecobase infrastructure improvement products are manufactured in Singapore under strict ISO manufacturing facility. ISO 9001:2008 Certification ISO 9001:2008 specifies requirements for a quality management system where an organization needs to demonstrate its ability to consistently provide product that meets customer and applicable statutory and regulatory requirements, and aims to enhance customer satisfaction through the effective [...]
Independent test data conducted by The University of Arkansas, Civil Engineering Department, USA, showed typical CBR increases of 250% to 300% with ECOBASE™ Soil Stabilizer. The California Bearing Ratio (CBR) test is a simple strength test that compares the bearing capacity of a material with that of a well-graded crushed stone (thus, a high quality [...]
Drying and Curing is a two-stage process. First ECOBASE™ Soil Stabilizer (Ecobase) dries and then it cures. Newly installed Ecobase can be used as intended as soon as the surface dries with no permanent damage. Any surface deformations can be rectified before it fully dries. Drying Time cannot be predicted with absolute accuracy because drying [...]
Environmental-Friendly Ecobase™ stabilisation products are environmentally friendly and eco-safe. They do not require any hazardous warning labels; it may be stored for extended periods of time. It is non-corrosive, non-flammable, non-allergenic and non-toxic. When used as designed and directed, Ecobase meets all U.S.A. Environmental Protection Agency (EPA) requirements and standards. “Green Benefits” for the environment [...]
ECOBASE™ is not subject to special DOT, OSHA, or EPA requirements for transportation, storage, handling or disposal of containers. It is non-hazardous, non-corrosive, non-flammable and non-toxic. When used as designed and directed, ECOBASE™ soil stabilizer meets all U.S.A. Environmental Protection Agency (EPA) requirements and standards.
Primary Uses unpaved and paved roads upgrading of rural roads and highway rehabilitation of failed roads construction sites and access roads parking areas air strips, runway, infields & aprons, helipad driveways material stock piles & slopes mine & quarry heavy haul roads mine tailing ponds & access roads cart & bike paths driving & walking [...]
Application of ECOBASE™ The application of ECOBASE™ will provide the following key benefits for the end-user. Increase bearing capacity Improve soil workability Provide all weather access even in wet conditions Minimize gravel loss Immediate & Long Term costs savings – ability to use in-situ soil for subgrade, subbase and base course layers, requires minimal or [...]
All ECOBASE™ products are manufactured under strict ISO 9001:2008 and ISO 14001:2004 standards. Depending on our clients’ location, our ECOBASE™ range of products can be manufactured and shipped out from Singapore or USA.
For an ECOBASE™ SS application, the following equipment are required. Motor Grader (recommended for road widths > 10m) OR Tractor with Rotavator/Grader attachment(s) for scarifying and grading purpose; Water Truck or IBC Tote with Spray Bar; and Compactor For ECOBASE™ Sealant application, the following equipment is required. Water Truck or IBC with Spray Bar Grader and Compactor [...]